Add/Edit a Module

Once a new IOP Test Template is created using the new Test Steps, a module can be created or edited to use the new IOP Testing Template.  Later, once a vehicle model/MY/trim is assigned to the same module, it allows the IOP testing results to be published on a front facing website.

Edit an existing Module

  1. From the IOP Dashboard, select Electronics.
  2. Select Electronics Modules.
  3. Select an existing Module.
  4. Edit the desired information.  NOTE: Changing the IOP Test Template could make devices previously tested with this module have incomplete results (if new test steps are introduced in the newly assigned IOP Testing Template).
  5. Select Save & Close.

Adding a New Module 

  1. From the IOP Dashboard, select Electronics.
  2. Select Electronics Modules.
  3. Select New from the top right.
  4. Enter the Electronics Module Name.
  5. Select an existing IOP Test Template.
  6. Turn ON the region(s) where this module will be used.  NOTE: This is important because some funcationality and how some of the information is displayed and offered is regionally dependent.  
  7. Select Save & Close.

Adding A New Module SW Version

It's importand when creating a new module to also add it's module SW version to be used later in test plans.  

  1. From the IOP Dashboard, select Electronics.
  2. Select Electronics Software Versions.
  3. Select New from the top right.
  4. Enter the SW Version information.
  5. Select the module that will be utilizing it.
  6. Select the released date (Released Sunset can be entered when the SW is no longer in production or being tested on).
  7. Select Save & Close.

 

After this is completed, the list of devices to regression test can be created and assigned to this new module using How To: Create a List of Devices To Be Regression Tested/

To set up Module Features, review How To: Establish Module/Vehicle Features.